Floturn recently purchased equipment needed to roll and weld custom precision tubing. Typical application include:
Our process uses a special rolling process that can roll sheets with pre-cut holes, perforations, etching, etc. End flats are minimal using our process as well. Tooling cost are minimal, run size can run from one pc. to thousands.
See chart below for technical information:
|Technical Information for Floturn Rolled and Wedled Tubing|
|Maximum Diameter||36″ (1,828 mm)|
|Minimum Diameter||2″ (50.8 mm)|
|Material Thickness Minimum||.015″ (.381 mm)|
|Material Thickness Maximum||.105″ (2.66 mm)|
|Maximum Length||36″ (914.4 mm)|
|Material Type||Stainless Steel, Steel, Aluminum, Brass, Copper
(any weldable metal)
|Diameter Tolerance||Varies depending on diameter, thickness, etc.
(+/- .010″ on smaller diameter, +/- .030″ on larger)
|Finish||2B Typical, special brush finish or pre-coated possible|
|Holes, Preforations, Etching||Incoming sheets can be pre-processed to include holes, preforations, slots, etching, etc before rolling and welding|